Glass workshop Harzer Schmalspurbahnen GmbH

Customer: Harzer Schmalspurbahnen GmbH
Location: Wernigerode
Country: Germany
Technical data: 13.500 x 5.100 x 5.000
Included services: Surface technology
Surface Technology Glass Workshop

Project details

At the new plant location in Wernigerode, a combined cleaning, painting and drying booth was planned and installed for the lenged Brocknebahn. The project was themed Glass Workshop: A factory hall accessible to tourists at all times required the highest standards not only in terms of technology but also in terms of execution


Cabin design
Entry/exit gate
Filter ceiling cabin
Extraction wall painting/drying
Suction wall Reingen
Closure valve sewage manhole
Cabin lighting
Ventilation units
Air ducts
Gas surface burner
Heat recovery
Paint mixing room
E-control cabinet, regulation, control, sensor technology
Engineering, planning, documentation
Full mechanical plant assembly
Commissioning and training of operating personnel
Acceptance expert
Mounting tools

Operating principle

The booth is to be built on an existing foundation and basically has 3 operating modes: During cleaning, the booth is ventilated diagonally via the filter ceiling at reduced air flow rate and exhausted via the two exhaust walls positioned on the rear wall. During painting, either the front or the rear area is ventilated at full air output. In dry (or evaporative) mode, the front and rear areas are evenly ventilated.